Safety Regulations For Airless Spraying; Explanation Of Symbols Used - Titan IMPACT 1040 Instrucciones De Uso

safety precautions
1
SAfeTy regulATIoNS for
AIrleSS SprAyINg

explANATIoN of SymBolS uSeD

1.1
This manual contains information that must be
read and understood before using the equipment.
When you come to an area that has one of the
following symbols, pay particular attention and
make certain to heed the safeguard.

This symbol indicates a potential
hazard that may cause serious
injury or loss of life. Important
safety information will follow.

This symbol indicates a potential
hazard to you or to the equipment.
Important information that tells
how to prevent damage to the
equipment or how to avoid causes
of minor injuries will follow.
 Danger of skin injection
Danger of ire from solvent and

paint fumes
Danger of explosion from solvent,
 paint fumes and incompatible
materials
Danger of injury from inhalation

of harmful vapors
Notes give important information
i
 which should be given special
attention.
4
hAZArD: INjecTIoN INjury
Attention: Danger of injury by
injection! A high pressure stream
produced by this equipment can
pierce the skin and underlying tissues,
leading to serious injury and possible
amputation.
Do not treat a spraying injury as a
harmless cut. In case of injury to the
skin through coating materials or
solvents, consult a doctor immediately
for quick and expert treatment. Inform
the doctor about the coating material
or solvent used.
preveNTIoN:
•
NEVER aim the gun at any part of the body.
•
NEVER allow any part of the body to touch
the luid stream. DO NOT allow body to touch
a leak in the luid hose.
•
NEVER put your hand in front of the gun.
Gloves will not provide protection against an
injection injury.
•
ALWAYS lock the gun trigger, shut the luid
pump of and release all pressure before
servicing, cleaning the tip guard, changing
tips, or leaving unattended. Pressure will not
be released by turning of the engine. The
PRIME/SPRAY valve or pressure bleed valve
must be turned to their appropriate positions
to relieve system pressure.
•
ALWAYS keep tip guard in place while
spraying. The tip guard provides some
protection but is mainly a warning device.
•
ALWAYS remove the spray tip before lushing
or cleaning the system.
•
NEVER use a spray gun without a working
trigger lock and trigger guard in place.
Impact 1040