Getting Started; Making Settings Using The Setup Navigator Menu - Pioneer BCS-727 Manual De Instrucciones

52

Getting Started

En
Capter 3
Getting Started
Making settings using
the Setup Navigator
menu
Be sure to perform these settings when using
the player in the following situations.
• When you use the player for the first time.
3
• After Initial Setup format.
• After updating the player's software.
Caution
• Before turning on the power, check that the
connections between the player and other devices
are correct. Also, turn on the power of the devices
connected to the player before turning on the
player's power.
• When using a Pioneer Flat Screen TV or front
projector compatible with the Control function,
set Control to On on the connected device before
turning on the player's power.
Note
• When a Pioneer Flat Screen TV or front projector
compatible with the Control function is connected
to the player using an HDMI cable, the player is
automatically set to the optimum picture quality for
the connected device.
1. Turn on the TV's power and switch the
input.
See the TV's operating instructions for the
details of operating the TV.
2. Turn on the player's power.
Press  STANDBY/ON.
Check that the Setup Navigator menu is
displayed.
 If the Setup Navigator menu is not
displayed
HOME MENU to display the
 Press
Home Menu, select Initial Setup d Setup
Navigator d Start, then press ENTER.
3. Start Setup Navigator.
Press ENTER.
y Setup Navigator starts.
4. Select the OSD language.
Use / to select, then press ENTER.
When a Pioneer Flat Screen TV that
is compatible with Control function is
connected to this player's HDMI OUT
terminal, language settings are imported
from the Pioneer Flat Screen TV's language
settings before Setup Navigator begins.
5. Select the appropriate output resolution
for the connected TV.
Use / to select, then press ENTER.
6. Select the appropriate aspect for the
connected TV.
Use / to select, then press ENTER.
7. Close the Setup Navigator menu.
Press ENTER.
y Setup Navigator finishes and the setting
is stored.
y Press RETURN to go back to the
previous screen.