Other Operating; Recording Audio Cd To A Usb Device - Pioneer BCS-727 Manual De Instrucciones

Chapter 7

Other Operating

Recording Audio CD to a
USB device
You can record audio CD to a USB device using
this player.
1. Insert an USB device into the USB port
on the front panel.
Note
y Please connect only one USB device.
2. Open the disc tray and place an Audio
CD on the tray.
Press  OPEN/CLOSE.
3. Close disc tray.
When  OPEN/CLOSE is pressed, playback
will start automatically.
y If playback does not start automatically,
press the  PLAY on the remote or /
(PLAY/PAUSE) on the device to start
playback.
4. Press USB REC during CD playback.
[CD RIP] will be displayed.
5. Select the song or the Track No. you
want to record.
If you are recording all the songs on the CD
use / / / to select [Select all] and press
ENTER.
If you are selecting a Track to record use
/ / / to select the Track No. and press
ENTER.
y If there are more than one Track you want
to record, repeat the step for 5.
y If you want to delete a selected Track use
/ / / to select [Select None] and
press ENTER.
6. Set the recording speed
Use / / / to select [Speed] and press
ENTER.
y The recording speed will change each
time ENTER is pressed. The recording
speed will change as shown below.
Normal: when recording while listening
to the music.
Fast: will record at approx 4x speed. You
cannot listen to the music.
7. Start recording.
Use / / / to select [Start] and press
ENTER to start recording.
8. Exit CD recording display.
Use / / / to select [Cancel] then press
ENTER after recording has finished.
Note
/ / / to select [Bitrate] then press
• Use cursor
ENTER to change the Bitrate setting.
The set speed will change each time [Bitrate] is
pressed. The set value can be selected from those
shown below.
[64kbps] d [96kbps] d [128kbps] d [192kbps]
d [256kbps] d [320kbps]
• A folder will be created on the USB device when
recording starts. The maximum number of folders
that can be created is 100.
Other Operating 69
En
7