Troubleshooting; Cleaning And Maintenance - Waeco PerfectBattery BC400 Instrucciones De Uso

MBCC-400.book Seite 29 Montag, 18. Februar 2008 4:00 16
PerfectBattery BC400
7

Troubleshooting

Please refer to the following error table before contacting customer services.
Problem
The yellow LED (fig. 1 9,
page 3) does not glow if you
connect the compact charger
to the AC mains.
The red LED (fig. 1 7,
page 3) glows.
8

Cleaning and maintenance

Caution - Danger of electrocution!
Always disconnect the mains plug before you clean and service the
device.
Caution - Danger of damaging the device!
Never clean the device under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during clean-
ing as these can damage the device.
➤ Occasionally clean the device with a damp cloth.
Cause
There is no AC voltage.
The polarity has been
reversed.
The cables have been short
circuited.
Electric consumers are con-
nected.
The charging current selected
for the battery is too low.
Troubleshooting
Remedy
Make sure that an AC voltage
is present.
Connect the connection termi-
nals with the correct polarity.
Check the electric cables.
Disconnect all electric con-
sumers which are connected
to the battery.
Use a charging device with a
higher charging current.
29