Corghi EM 9580 Manual De Uso página 62

- if only one measurement is taken, the machine
interprets the presence of a rim with balancing
using a clip weight on both sides (Dynamic
Balancing Programme)
- moving the arm to the rest position, the machine
will set up for the manual WIDTH entry.
- in this phase, it is possible to perform an ad-
ditional acquisition of the rim diameter and
distance.
- Measure the width of the rim using the caliper
provided (fig. 15).
- Change the displayed width value by increasing
or decreasing the value using the keypad
turning the kis.
After updating the wheel data the user can:
1) Press the Exit
unbalance values recalculated according to
the new dimensions.
2) Press pressing the Kis knob or
62
15
or
button to display the
the Enter
button to access the Manual dimension
programme to convert and/or change the
wheel data.
- if two subsequent measurements are taken
inside the rim on two balancing planes, the
machine interprets the presence of a rim with
balancing using a clip weight on the inner
plane and an adhesive weight on the external
one (ALU 2P). In this phase, the machine could
automatically change the type of weight on the
inner plane from clip to adhesive (ALU 1P).
Returning the arm to the rest position makes it
possible for the operator to change this setting,
selecting and using the Kis knob or the enter
button to press the icon
the balancing programme switches from ALU 1P
to ALU 2P and vice versa.
EM 9580 - Operator's manual
ALU2P
ALU1P
. In this case,