Dometic GROUP WAECO CoolAir RT880 Instrucciones De Uso página 39

RT880/SP950
7.6 Switching off the parking cooler
You can switch the parking cooler to standby mode or switch it off completely.
Note that the parking cooler consumes power in standby mode. Therefore,
switch off the RT880 parking cooler and SP950 with SP950I rear panel
evaporator unit whenever possible.
Due to the design, the condensation must be pumped off from the SP950
parking cooler with SP950T roof evaporator unit. Therefore, switch the
SP950 parking cooler with SP950T roof evaporator unit to standby mode
after use and any subsequent journey while in motion. The condensation
which accumulated during and after operation is then drained off.
Switch off the parking cooler completely when it is not in use and for longer
periods (e. g. over the weekend).
I
NOTE
You can only use the remote control to switch the parking cooler
in and out of standby mode.
SP950
➤ Switching to standby mode:
With the unit switched on, briefly press the ON/OFF (fig. 2 1, page 4)
button or the
✓ The digital display goes out, only the blue power LED lights up.
✓ The compressor and the fan switch off.
➤ Switching the unit off completely:
With the unit switched on, press the ON/OFF (fig. 2 1, page 4) button for
3 seconds.
✓ The LEDs and digital display go out.
✓ The fan and the compressor switch off.
EN
(fig. 3 1, page 4) button on the remote control.
Using the parking cooler
39