Remote Control; Replacing The Battery; Stove Cleaning - Ferroli TERMO MODENA Manual De Instalación, Uso Y Mantenimiento

4.7

Remote control

The remote control is a device that transmits through an infrared diode. Therefore it must be pointed towards the
receiver unit fitted in the control panel.The remote control allows the following operations:
P1 and P3: Buttons to set the power
level
P5: Button for accessing the MENU
P7: Button to activate/deactivate
ECO mode
P9: On/Off button and for exiting the
MENU

4.7.1 Replacing the battery

The remote control is powered by a 3-volt CR2025 type battery located in the bottom of the device. For its insertion
and possible replacement, proceed as follows:
- Operate the lever indicated;
- Pull out the battery tray and replace the battery ( 3-volt CR2025 model ) respecting the polarity;
- Insert the tray;
- Check proper functioning.
- Keep the remote control away from direct heat sources and water.
-The remote control battery must be replaced and disposed of safely in compliance
with local regulations.
4.8 Installation procedure
The stove installation procedure depends on the type of water system it is connected to. It can also differ
depending on the use of an external thermostat or the internal probe.
For the correct electrical and water connections, contact a specialised technician.
4.9 Idle period (end of season)
If the stove is not used for long periods, and/or at the end of each season, it is advisable to proceed as follows
- remove all the pellets from the hopper;
- disconnect the power and remove the power cable;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- protect the stove from dust with suitable covering;
- store in a dry and safe place protected from atmospheric agents.

5 STOVE CLEANING

Stove cleaning is very important to prevent: blackening of the glass, poor combustion, deposits of ash and unburnt
products in the brazier, reduced thermal efficiency.
The stove must only operate with the fire door closed.
The fire door seals must be checked periodically to prevent any air from entering; the combustion chamber and
pellet duct work in a negative pressure and the fume exhaust in a positive pressure.
Routine cleaning is normally carried out by the customer following the instructions in the manual, whereas
extraordinary maintenance, at least once a year, must be performed by the authorised Service Centre.
P2 and P4: Buttons for setting the
temperature
P6: Button to exit the MENU
P8: Button to activate/deactivate
STANDBY mode
P10: Button to activate/deactivate
the CHRONO function
43
battery tray
lever
TERMO MODENA