Publicidad
Idiomas disponibles
Idiomas disponibles
B
Assembly
For the next steps, prepare the elements of the magnetic holder
individually and place them far apart from each other - there is
otherwise a risk of injury
Using light pressure and by making a rotating motion, insert the damping
buffer into the two lower and upper openings of the pump holder (Fig.
B
). Connect the pump holder to the magnetic holder designed for the
1
inside of the aquarium (Fig. B
Now, position the pump holder with the magnet in the desired spot in
the aquarium and lock into position with the magnetic holder from the
outside. Click the EHEIM streaming pump into the pump holder below
the water (Fig. B
C
Putting into operation
Place the streaming pump into the aquarium in such a way that it will
not cause any damage if it accidentally falls off.
So that the pump does not draw-in any air, it should be mounted
approximately 10 cm below the surface of the water. Set the desired
direction of flow by rotating sideways to the left or right when holding
plate is positioned vertically (Fig. C
backwards or forwards if the pump holder is positioned horizontally (Fig.
C
and C
).
3
4
By shifting the output regulator
(shift by lightly pressing on both sides of the output regulator), the flow
rate can be adjusted as required (Fig. C
Switch on using the mains plug.
D
Care and Cleaning
Unplug the mains plug and make sure that the pump is de-energized. To
remove the pump, gently press the tab on the pump holder away from
the pump and remove the pump by tilting it backwards out of the holder
(Fig. D
). Use a brush or a sponge to clean away coarse dirt from the
1
pump basket. Remove any blockages from the flow opening if they are
clogged.
2
).
3
).
and C
) or by inclining the pump
1
2
within the –min. and +max. range
/ C
5
6
).
Publicidad
