Exchange - Projector Lamp - Astralpool Aroma 1.5-23 Manual Del Operador

7.3. Exchange of the projector lamp
Type of lamp:
7.3.1.1. Exchange of the lamp
Concerning all service works, strictly pay attention that the sensitive
optical fibres are not dammaged. In case of break of the fibres, no
more light is transported resp. the tub can become leaky!
In general, only the indicated type of lamp may be used. Stronger
lamps or lamps of another type may not be used for safety reasons.
7.3.1.2. Proceeding
The light projector is installed under the tub back rest.
-
First assure that the tub is completely currentless!
Detach the tub cladding, compare chapter „install cladding".
-
The two cover screws of the light projector are unscrewed and the cover diplaced
-
in direction of the optical fibres until the halogen lamp can be seen in the reflector.
Is the cover hindered in its deplacement because of an unfavourable lying of the
-
optical fibres, the fibre bundle can be removed from the projector. The attachment
screw of the fibre bundle is removed by the delivered socket wrench and the fibre
bundle can completely be extracted. The box can now be completely opened.
Remove connector of the lamp and extract the lamp of the holder.
-
Take the new lamp with a clean tissu out of its packing and carefully insert it in its
-
holder.
Please take care that you do not touch the reflector and the bordered lamp with
-
your hands, as grease can make the reflector resp. the lamp blunt or blind during
operation with great heat.
The connector is related with the connection pins of the lamp by pressing it.
-
Push the cover flatly and fix it with the screws.
-
If you detached the fibre bundle, put it as far as it will go into the projector
-
guidance by the coupling and fix it with the socket screw.
Before you attach the cladding, first check the functionality of the lamp and the
-
ventilator of the projector. On this occasion, remove the projector of dust deposits
near the fan guard.
Should the lamp abrade extremely often, a defect fan can be the reason. Please
-
contact our client service.
(The drawings correspond to any configuration, they could differ from the original display!)
Manual Aroma 1.5-23
100 W / 12 V / KSL GX 5,3
20.04.09 38