Operation; General Operation Steps; Main Switch - Astralpool Aroma 1.5-23 Manual Del Operador

5.

Operation

5.1.

General operation steps

5.1.1. Main switch

The unit can be turned on or off with the main switch installed by customer next to
-
the unit.
After switching-on, the unit is in standby operation.
5.1.2. Switch on and off – control
Switch on:
-
With putting the control button, the control is switched on.
The „start window" is opened.
Standby:
-
If there is no input at the control panel, the control switches to standyby
automatically after 20 minutes, when there is no tub fontion acitvated.
Or:
-
Mark „off field"in the function bar of the start window with the cursor and
confirm with enter. The control switches into standby mode.
5.1.3. Filling of the tub
Position the start panel on the menu point „bath preparation" and open the filling
-
valves (warm/cold). The inlet thermometer indicates the current filling
temperature. The filling level is achieved when the above liying nozzles are at
least 5 cm under water.
In case of units with the option „automatic filling via thermostate valve", the filling
-
effects via the operation table. There are two different filling levels to choose.
Open menu „bath preparation".
Mark the correspondent filling level with the cursor and confirm with enter.
The tub is filled up to the selected filling level.
With the thermostat, the temperature can be adjusted. The inlet thermometer of
the menu indicates the current filling temperature.
After having reached the filling level, further operation steps can be effected at the
-
operation panel.
(The drawings correspond to any configuration, they could differ from the original display!)
Manual Aroma 1.5-23 20.04.09 8