Outdoor Sensor Operating Elements; Start-Up Operation; Settings; Setting The Weather Forecast - Soehnle Page Meteo Center Manual Del Usuario

5. Outdoor sensor operating elements (Dia. 6)
TX
RESET
CH1CH2CH3 select radio channel (in case of different devi-

6. Start-up operation

1. Insert batteries (2 x 1.5 V AAA) into outdoor sensor (Dia. 2).
2. Insert batteries (3 x 1.5 V AAA) into scale (Dia. 1).

7. Settings

If no key is pressed for 60 seconds during setting, the display
switches back to normal mode.

7.1 Setting the weather forecast

1. After inserting batteries or after pushing the RESET button, all
LCD elements are displayed for 3 seconds. The display then
switches to the flashing sun symbol
2. Use the UP/DOWN keys to set the current weather condition
based on your personal weather observation (sunny, cloudy,
rainy)
3. Confirm using SET key.
Then the weather station searches for the radio signal of the
outdoor sensor and displays the current radio channel and the
measured values of the outdoor sensor (takes up to 30 minu-
tes). The outdoor sensor transmits measured values every 5
minutes. The weather forecast is updated hourly.
Note: To set the weather forecast at a later time, push and hold
the WEATHER key for 2 seconds until the display flashes.
Note regarding weather forecast: the weather forecast is based
only on temperature and air humidity measurement according
to the following principle:
Recalibration occurs once daily (11:00 a.m.) based on the
measured temperature and air humidity values.
The forecast is then determined once every hour, on the hour,
based on the comparison of the current and the last measured
values.
A detailed description of the weather forecast is available at
www.soehnle.com/service/pagemeteocenter".
immediate transmission of a signal to the scale
test button for function test (LED)
ces with radio connection in same range)
.
13
GB