Operating Elements; Technical Data - Soehnle Body Control Easy Fit Instrucciones De Manejo

A. Operating elements
EN
1. Plus (▲)
2. Confirm ( )
3. Minus (▼)
Sensor Touch: Touch
keys only slightly!
B. Preparation
1. Remove battery strip.
Note: Immediately (as long as „0.0" is still
being displayed) place the body analysis scale
on a level surface and wait until the scale
powers down automatically.
Then begin data input. Otherwise, it might be
possible that the weight of the scale would
erroneously be added to the initial weighting
process.
The same might occur during regular operati-
on if the scale is held in the hand prior to the
weighting process.
2. For all measurements, place scale level on a
hard surface (not carpet).
3. Cleaning and Care: clean only using slightly
damp cloth. Do not use solvents or abrasives.
Never submerge scale in water.
4. A country-specific option to switch from kg/cm
to lb/in or st/in is possible by pushing the key
on the bottom of the scale to switch units.
Attention! Slipping hazard
in case of wet surface.
4
C. Data input
1. Push key.
2. Use ▲/▼ keys to select memory slot and con-
firm ( ).
3. Then use ▲/▼keys enter body height.
Use to confirm.
4. In the next step enter the age and confirm.
5. Finally select sex and confirm.
6. Place scale on hard, level surface and wait
until the scale switches off automatically.
Note: Changing or deleting data is done by
overwriting existing data.
D. Body analysis
1. Place scale on hard, level surface and wait
until the scale switches off automatically.
2. Use ▲/▼ keys to select memory slot and con-
firm ( ).
3. Wait for display to show "0".
4. Step barefoot onto scale. Please stand still.
5. The body weight will be displayed.
The scale determines the body values (body
fat, body water, muscle mass, kcal).
Note: Body values are calculated based on the
determined weight and the personal data.
The scale shuts off auto matically.
E. Notifications
1. Replace batteries
2. Overload: max. 180 kg
F. Technical data
Max. 180 kg/100 g
Max. 400 lb/0.2 lb
Max. 28 st/0.2 lb
Batteriy requirement: 1 x 3V CR 2032