Installation - Edesa FQ8E205A6 Manual De Instrucciones

INSTALLATION

RECOMMENDATIONS
Allow air to circulate behind the refrigerator.
Do not cover the front grill or top of the refrigerator with any object. If the refrigerator is
placed underneath a cupboard, leave a space for air to circulate.
Your refrigerator's climate classification is stated on the specifications plate, and defines the
room temperature range for which the cooling unit
is designed, at which the apparatus is guaranteed
to operate correctly. Where two classes are indicated,
the unit will operate correctly in both.
As far as possible avoid locating near to
heat sources.
If the refrigerator needs to be laid down for
unpacking or to change the direction of the
doors, ONLY LAY IT DOWN ON THE REAR
SECTION.
NOTE: The door hinges are on the right. If this is inconvenient the
hinges can be changed to the other side. Instructions are
contained in the section on changing the direction of door
opening.
IMPORTANT. Ensure that the refrigerator is
well seated on the ground (without
movement) and is properly levelled (without
tilting) by adjusting the levelling feet.
This refrigerator operates at 220/230 v. If the voltage
in your home is different, a transformer should be
used with an outpout of not less than 500 W.
Use an EARTHED plug.
NOTE: The manufacturer will not accept any liability
in the event that these recommendations are not
followed.
BEFORE CONNECTING TO THE POWER
1.- Clean the inside of the refrigerator.
2.- Wait for 2 hours before connecting, to ensure proper functioning.
3.- Connect to the power.
Type
N
ST
T
2
Temperature range
16º - 32º
18º - 38º
18º - 43º