Quick Program - Steren RM-7 Manual De Instrucciones

Quick program

Before using your new Universal Remote Control be sure that you has
installed 2 new alkaline batteries type AA (RM-7) or 3 new alkaline batteries
type AAA (RM-8) or with enough charge.
You can use the quick program with the enlisted codes, that you can see
on the next pages. If your device does not respond or is not functioning
properly, please try with each code listed for your brand. If it's necessary, try
the Search Method.
1.- Press and hold SET (6). Then press the corresponding key, to program
your desired device (TV, DVD, VCR, etc). The indicating LED turns on.
2.- Find the code for your device in the codes list and enter the 3 digits code.
The indicating light turns off.
3.- Now aims the remote control at your device, and press POWER (1).
If your device switch on, you are ready to operate the device. Ckeck that
your device works properly with the remote control. If your device does not
respond or is not functioning properly, please try with each code listed for
your brand, repeating from step 1 to 3. If is necessary, try the Search Method.
Notes:
Do not exceed more than 10 seconds between each step. Otherwise, the
remote control exit from the Program Mode and you must start again.
Probably there are more than one code for your device, but only one of
them will control almost the total of functions, try to find the more appropriated
code for your brand.
9 9