Factory Reset - Shure Microflex Wireless System Preparación Rapida

Factory Reset

If a device isn't appearing on the network after trying troubleshooting methods, perform a reset on the specific hardware to return the device to default
settings. Factory default settings are designed for automatic compatibility with other Shure networked devices.
Note: A factory reset will clear any MXW Group and Link associations. The password to access the software will reset to
From the Control Software
1. Open the Utility Tab of the MXW control software.
2. Select the desired devices by clicking on the checkbox on the right column.
3. Click the Factory Reset button at the top of the page to return each selected device to factory default settings.
From the Hardware
Access Point Transceiver
Press and hold the recessed reset button for 10 seconds. The network audio status LED will briefly
turn off to indicate the unit is rebooting.
CAUTION: A factory reset deletes all Group associations and microphone Links saved in the
device.
Audio Network Interface
Press and hold the reset button for 10 seconds. The front panel LEDs will flash to indicate the unit is
rebooting.
Networked Charging Station
1. Turn off the power switch.
2. Press and hold the Link button.
3. While holding the Link button, turn on the power switch.
4. Continue to hold the Link button for 12 seconds until the LED illuminates amber.
8
.
admin
10
9
8
+
link
12
11
1
2
3
4
7 5
6
1
9
link