Service; Evans.com.mx Propiedad Evans.com.mx Propiedad Evans; Cutting Deck Removal; Propiedad Evans.com.mx Propiedad Evans.com.mx Propie - MTD 760 Serie Manual De Operador

EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.

Service

PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE

EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.

Cutting Deck Removal

NOTE: Models equipped with a 38-inch deck have one deck idler
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
pulley. Models equipped with a 42- and 46-inch deck have two
deck idler pulleys.
To remove the cutting deck, proceed as follows:
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
1. Place the PTO (Blade Engage) lever in the disengaged (OFF)
position and engage the parking brake.
2. Lower the deck by moving the deck lift lever into the
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
bottom notch on the right fender.
3. Removing the self-tapping screw (A) that secures the belt-
keeper rod from around the tractor's engine pulley, then
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
remove the belt keeper rod (B). See Figure 7-1.
Note: Make a mental note what hole the other end of the belt-
keeper rod is inserted in for reinstallation purposes.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
4. Remove the belt (C) from around the tractor's engine
pulley. See Figure 7-1.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
WARNING!
your fingers on the idler spring or between the belt
and a pulley while removing the belt.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
5. On 38" Decks: Looking at the cutting deck from the left
side of the tractor, locate the bow-tie pin that secures the
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
deck support rod on the rear left side of the deck. See
Figure 7-2. Remove the bow-tie pin that secures the deck
support rod, and carefully remove the deck support from
the deck lift arm.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE 24
C
Figure 7-1
Avoid pinching injuries. Never place
6. On 42" Decks: Remove the bow-tie cotter pin securing
the deck lift rod to the deck. Slide the deck lift rod from the
mounting weldment on the deck as seen in Figure 7-3.
A
7. Repeat the above steps on the tractor's right side.
NOTE: The bow-tie hair-pin clips should be re-installed
from the top down.
B
Figure 7-2
Figure 7-3
7