Mitsubishi FX2N SERIE Manual Del Usaurio página 57

FX2N Series Programmable Controllers
Caution
ENG
• Units should not be installed in areas subject to the following conditions: excessive or conductive dust, corrosive
gas (salt air, Cl
excessive vibration.
• Take special care not to allow debris to fall inside the unit during installation e.g. cut wires, shavings etc. Once
installation is complete remove the protective paper band to prevent overheating.
• During transportation avoid any impact as the PLC is a precision instrument.
It is necessary to check the operation of PLC after transportation, in case of any impact damage.
• During transportation avoid any impact to the battery (F
leakage etc. from the battery.
• When storing the PLC, conform to the environmental conditions specified by the general specification.
When the battery is left attached, it is necessary to avoid direct sunshine, high temperature, high humidity and
water splash.
• Use the battery for memory backup correctly in conformance to the manual of each product.
- Use the battery only for the specified purpose.
- Connect the battery correctly.
- Do not charge, disassemble, heat, put in fire, short-circuit, connect reversely, weld, swallow or burn the battery,
or apply excessive forces (vibration, impact, drop, etc.) to the battery.
- Do not store or use the battery at high temperatures or expose to direct sunlight.
- Do not expose to water, bring near fire or touch liquid leakage or other contents directly.
- Incorrect handling of the battery may cause heat excessive generation, bursting, ignition, liquid leakage or
deformation, and lead to injury, fire or failures and malfunctions of facilities and other equipment.
• Please contact a certified electronic waste disposal company for the environmentally safe recycling and disposal of
your device.
When disposing of batteries, separate them from other waste according to local regulations.
(For details of the Battery Directive in EU countries, refer to Appendix E)
• Before transporting the PLC, turn on the power to the PLC to check that the BATT.V LED is off.
If the PLC is transported with the BATT.V LED on or the battery exhausted, the batterybacked data may be
unstable during transportation.
• When transporting lithium batteries, follow required transportation regulations.
(For details of the regulated products, refer to Appendix D)
, H S, SO , NO , etc.) or flammable gas, moisture or rain, excessive heat, regular impact shocks or
2 2 2 2
-40BL) as the PLC may be seriously damaged by liquid
2
Installation 3
1
2
3
4
5
6
7
A
B
C
D
E
3-9