Connection With The Mains; Operation; Cleaning And Maintenance - EuroLite 51101465 Manual Del Usuario

Procedure:
Step 1: Remove the lamp from the socket. (See Procedure under Installing/Replacing the lamp)
Step 2: The holes for the installation are on the baseplate.
Step 3: Hold the baseplate onto the location where the device is to be installed.
Step 4: Mark the boreholes with a pen or a suitable tool.
Step 5: Drill the holes.
Step 6: Hold the baseplate in the desired position and tighten it with the screws included in delivery.
Step 7: Carefully install the lamp into the socket.
Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

Connect the effect to the mains. With the ON/OFF-switch, you can switch the device on and off.
After you connected the device to the mains, the neon-tube needs 3-4 minutes warm-up time until it reaches
full lighting output.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
DANGER TO LIFE!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
12/23 00019072.DOC Version 1.2