Connection With The Mains; Operation; Auto Mode - EuroLite LED Floodlight 252 RGB Manual Del Usuario

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After you connected the spot to the mains, the EUROLITE LED Floodlight 252 RGB starts running.

Auto Mode

In order to select Color change and Color fade, set dipswitch 9 and 10 to OFF. Set dipswitches 1 – 6 to
OFF as well.
International
L
N
18/37 51913860_V_1_0.DOC