Storage; Preparation For Storage; Transport; Preparation For Transport - Parkside PGI 1200 B2 Manual De Instrucciones

Fuel filter:
NOTE
► The fuel filter is a filter cup that is located directly under the filler
cap and filters all fuel that is added.
♦ Set the On/Off switch into the "OFF" position.
♦ Open the filler cap .
♦ Remove the fuel filter and clean it using a non-flammable solvent.
♦ Replace the fuel filter .
♦ Close the filler cap .
Oil change:
The engine oil should be changed with the engine at operating temperature.
♦ Use only engine oil (15W–40).
♦ Open the oil filling plug and drain the warm engine oil into a
collection container by tilting the generator.
♦ Top up with new engine oil (approx. 0.25 l).
♦ Close the oil filling plug .
♦ Place the generator back on a stable, flat surface.
Automatic oil switch-off:
The automatic oil switch-off is triggered when there is too little engine oil.
The low oil indicator starts flashing if there is too little oil in the engine.
The control lamp lights up when the oil quantity has fallen below the safety
limit. After a short while, the engine switches off automatically. A restart is
only possible after the oil has been topped up (see section "Oil change").
PGI 1200 B2

Storage

Preparation for storage

♦ Empty the fuel tank using a petrol suction pump.
WARNING!
► Do not remove the fuel in closed rooms, in the vicinity of fire or while
smoking. Gas vapours can cause explosions or fire.
♦ Start the engine and leave it running until the remaining petrol has
been used up.
♦ Change the oil after every season (see section "Maintenance
schedule"). To do this, drain the old engine oil from the warm engine
and refill with new oil.
♦ Remove the spark plug . Use an oil can to fill approx. 20 ml oil in
the cylinder. Pull the starter pull cord
inside of the cylinder. Screw the spark plug
♦ Store the appliance in a well-ventilated location.

Transport

Preparation for transport

♦ Empty the fuel tank using a petrol suction pump.
♦ If operational, allow the engine to run until the remaining petrol is used up.
♦ Remove the engine oil from the warm engine (see section
"Cleaning and maintenance").
♦ Remove the spark plug connector
♦ Secure the appliance against slipping using securing straps.
♦ Transport the appliance holding it by its handle
slowly so that the oil coats the
back in.
from the spark plug .
.
GB │ IE │ 17
■