Installation Procedure - Toto TS930A1 Manual De Instrucciones Y Del Propietario

N OTE: The product is heavy. Use the
recommended mounting support as
shown to suppor the shower prior to
installation.
1) Thoroughly clean and remove any de-
bris from the water supply pipe before
installation to prevent clogging the
spray outlet.
2) Complete the finished wall with a
1-1/2" clearance hole.
Slide the escutcheon and mount-
ing bracket onto the shower arm as
shown.
Apply an adequate amount of pipe
tape on the threads and thread the
shower arm into the supply elbow.
3) Slide the mounting bracket back
against the wall and tighten with pan
head screws and washers.
Secure the mounting bracket onto
the wall with mounting screws. Slide
the escutcheon toward the wall over
the mounting bracket.
FOR TS930A1/TS930A1L ONLY:
Make sure that the flow regulator
and gasket are both properly in-
stalled in the showerhead adapter.
Thread the showerhead adapter into
the shower arm adapter until it is
tight.
Adjust the showerhead so that the
TOTO logo is parallel to the wall
®
(slightly loosen the showerhead if
necessary), then tighten with set
screws.

INSTALLATION PROCEDURE

4
2 x 6
Brace
1-1/2"
Clearance
Hole
Supply Line
Mounting
Bracket
Escutcheon
TS930A1
TS930A1L
Mounting
Screws
Shower
Arm
Adapter
Set
Screws
Flow
Regulator
Gasket
2 x 4
Brace
1/2"
NPT
Elbow
1-1/2"
Clearance
Hole
1-1/2"
[40mm]
Pan
Head
Screws
Washers
Showerhead
Adapter