Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION PROCEDURE
1. SPOUT INSTALLATION
■ Make sure water supply is turned off.
■ Remove the plug from the spout shank.
■ Loosen set screw on the back of the spout.
Remove the spout adapter.
■ Thread the spout adapter onto the spout shank.
Take care not to damage the O-ring.
■ Carefully insert the spout onto the spout adapter.
Take care not to damage the O-rings.
■ Secure the spout with set screw.
2. LEVER HANDLES INSTALLATION
■ Thread the escutcheon onto the deck adapter.
■ Install the stem adapter onto the valve stem.
Secure with screw.
■ Slide the lever handle onto the stem adapter.
Secure the handle with set screw.
Spout
Set Screw
Spout
Adapter
Finish Deck
Plug
Rough Deck
Handles
Set
Screws
Screws
Stem
Adapter
Escutcheons
Deck Adapter
4
PLOMBERIE
FERME
10-1/8" (25.7cm)
2-15/16"
(7.5cm)
3.5"
3-1/4" (8.3cm)
(8.9cm)
Plan horizontal fini
1/4" (.64cm) MIN
5/8" (1.6cm) MAX.
Epaisseur du plan
horizontal brut
1/2" NPSM
1-1/2" (3.8cm) MAX.
17
FROID
CHAUD
FERME
OUVERT
OUVERT
22, 80 cm
à 40,60 cm
3-13/16"
2-1/8"
(9.7cm)
(5.4cm)
2-3/16"
(5.6cm)
1-1/4"
1-1/2"
(3.2cm)
(3.8cm)
1/2" NPSM
Publicidad
Tabla de contenido
