Adjusting Depth Of Cut; Switch Action - Makita 5377MG Manual De Instrucciones

Adjusting depth of cut

007393
CAUTION:
After adjusting the depth of cut, always tighten the
•
lever securely.
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Bevel cutting
Positive stopper
22.5 51.5
45
2
007394
Turn the positive stopper so that the arrow on it points
one of three positions (22.5°,45°,51.5°). Then, tilt the
tool base until it stops and secure the base with the lever.
At this time, the same angle as the one that the arrow
points is obtained.
Setting bevel angle
Loosen the lever and tentatively set the tool base at the
0°bevel angle, then tighten the lever securely.
Turn the positive stopper so that the arrow on it points
one of three positions (22.5°,45°,51.5°) that is equal to
or greater than the desired bevel angle.
Loosen the lever again and then tilt and secure the tool
base at the desired angle securely.
NOTE:
When changing the positive stopper's position,
•
loosening the lever and tilting the bevel angle to
less than the desired stopper position number
allows to change it.
When the arrow on the positive stopper points 22.5,
•
1. Lever
1
1. Lever
2. Positive stopper
1
51.5
22.5
45
the bevel angle can be adjusted 0 - 22.5°;when the
arrow points 45, it can be adjusted 0 - 45°; when
the arrow points 51.5, it can be adjusted 0 - 51.5°.
Sighting
A B
007395
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.

Switch action

007396
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Hook
1
007397
CAUTION:
Always unplug the tool when hanging the tool
•
using the hook.
Never hook the tool at high location or on
•
potentially unstable surface.
The hook is convenient for hanging the tool temporarily.
7
1. Base
1
1. Switch trigger
1
1. Hook