5 Preparing Charger for Use
4.10 Cleaning, Maintenance and Repairs
WARNING
■ Aggressive cleaning agents, cleaning with a jet of water or
pointed objects can damage the charger. If the charger is
not cleaned correctly, components may no longer function
properly or safety devices may be rendered inoperative.
This can result in serious injuries.
► Clean the charger as described in this instruction
manual.
■ If the charger is not serviced or repaired correctly,
components may no longer function properly or safety
devices may be rendered inoperative. This can result in
serious or fatal injuries.
► Do not attempt to service or repair the charger.
■ If the connecting cable has a malfunction or is damaged:
► Have connecting cable replaced by a STIHL servicing
dealer.
5 Preparing Charger for Use
5.1
Preparing Charger for Use
Perform the following steps before starting work:
► Make sure the charger is in a safe condition, @ 4.5.
► Clean the charger, @ 9.1.
► If you cannot carry out this work: Do not use the charger
and contact your STIHL servicing dealer.
6 Charging the Battery, LEDs
6.1
Mounting the Charger on a Wall
The charger can be mounted on a wall.
0458-967-9921-A
2
1
a
b
a
► Check the following points when mounting
the charger on a wall:
– Suitable fixing materials.
– The charger is level.
– The following dimensions are observed:
– a = at least 100 mm
– b = 54 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
6.2
Charging the Battery
The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see
www.stihl.com/charging-times.
The charging process starts automatically
when the plug is inserted in a wall outlet and
the battery is fitted in the charger. The
charger switches itself off automatically when
the battery is fully charged.
The battery and charger become hot during the charging
process.
English
3
d
e
e
19