// USER MANUAL
COMPONENT TASK
Tires / sealing fluid
Remove the tires and check them for damage and embedded foreign objects. At
the same time check the tubeless rim tape, see above.
Replace or refill sealing fluid if necessary. Remove dried sealing fluid from the
tires.
We recommend 30 ml sealing fluid per tire.
Gears / drive system Check wear of the chain with a chain wear gauge.
→ The chain must be replaced when the maximum permissible elongation
is measured with the chain wear gauge.
The chainrings and the cassette should also be replaced when replacing the
second chain.
Check the adjustment of rear derailleur and front derailleur.
When using an electronic gearshift or electronically dropper seat post: Change
button cells.
Battery type: CR2032
*h = operating hours For intervals with km- and h-intervals, the event that occurs first applies.
INTERVAL
3 months
for the first time after 1000 km, then regularly
3 months
2 years or when red LED is on or blinking
8.2
FURTHER INFORMATION
If you are sure that you have sufficient knowledge and skills, you can find all the necessary information about the above mentioned tasks on the websites of the component manufacturers. Please mind that
you take responsibility for all jobs carried out by yourself and that warranty and guarantee claims expire in case of incorrect service or installation.
• SRAM / Rock Shox: sram.com/service
• Magura:
www.magura.com/de/components/techcenter/
• Newmen:
www.newmen-components.de
• Fox:
www.ridefox.com
• Sixpack:
www.sixpack-racing.com
• Bikeyoke:
www.bikeyoke.de
• Stans:
www.notubes.com
• Crankbrothers:
www.crankbrothers.com