General Power Tool Safety Warnings - Makita CC300D Manual De Instrucciones

ENGLISH (Original instructions)
1. Buttons
2. Battery
3. Clamping screw
4. Depth guide
5. Bevel scale plate
6. Cutting line
7. Lock-off lever
8. Switch trigger
9. Shaft lock
10. Hex wrench
SPECIFICATIONS
Diamond wheel diameter
Max. Cutting depth
No load speed (n
Overall length
Rated voltage
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in glass and masonry
materials with a diamond wheel and water.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS CUTTER SAFETY
WARNINGS
Cut-off machine safety warnings
1. The guard provided with the tool must be securely
attached to the power tool and positioned for
maximum safety, so the least amount of wheel is
exposed towards the operator. Position yourself
and bystanders away from the plane of the
rotating wheel. The guard helps to protect operator
from broken wheel fragments and accidental contact
with wheel.
2. Use only diamond cut-off wheels for your power
tool. Just because an accessory can be attached to
your power tool, it does not assure safe operation.
4
Explanation of general view
11. Tighten
12. Loosen
13. Inner flange
14. Diamond wheel
15. Outer flange
16. Hex bolt
17. Protrusion (bigger side)
18. Tank holder
19. Screw A
20. Notch
Model
at 0°
at 45°
) / Rated speed (n)
0
Net weight
3. The rated speed of the accessory must be at least
ENE025-1
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated
speed can break and fly apart.
4. Wheels must be used only for recommended
applications. For example: do not grind with the
GEA010-1
side of cut-off wheel. Abrasive cut-off wheels are
intended for peripheral grinding, side forces applied to
these wheels may cause them to shatter.
5. Always use undamaged wheel flanges that are of
correct diameter for your selected wheel. Proper
wheel flanges support the wheel thus reducing the
possibility of wheel breakage.
6. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
7. The arbour size of wheels and flanges must
GEB053-3
properly fit the spindle of the power tool. Wheels
and flanges with arbour holes that do not match the
mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of
control.
8. Do not use damaged wheels. Before each use,
inspect the wheels for chips and cracks. If power
tool or wheel is dropped, inspect for damage or
install an undamaged wheel. After inspecting and
installing the wheel, position yourself and
bystanders away from the plane of the rotating
wheel and run the power tool at maximum no load
speed for one minute. Damaged wheels will normally
break apart during this test time.
21. Motor housing
22. Screw B
23. Tank
24. Tube
25. Cap
26. Open
27. Water supply cock
28. Close
CC300D
85 mm
25.5 mm
16.5 mm
-1
1,400 (min )
300 mm
D.C. 10.8 V
1.7 kg