Pioneer PDK-TS01 Manual De Instrucciones página 12

2. Stand attaching to the Plasma Display
Normal Installation
With the plasma display lying flat, insert and secure the two Installation bolts 1 (M8 x 20)
Step 1.
in the holes "a" located in the plasma display housing.
At this point, tighten these bolts 1 only until the threads are no longer visible when
viewed from t he side (you will be unable to attach the display if the bolts are screwed in
completely).
Plasma display
Regarding the stand pipe screw holes when the stand is used as a desktop stand
Table: Stand pipe screw holes when the stand is used as a desktop stand
Plasma display model
50"
43"
Note: Holes C and C' are for attaching options available separately, etc.
12
Specifications
Normal use
With optional speakers attached to both sides of display
Without optional speakers
With optional speakers attached to both sides of display
With optional speakers attached at bottom of display
C
B
A
C ´
B ´
A ´
Installation bolt 1 (M8 x 20)
Holes "a"
(holes in center of
plasma display)
C
B
A
C ´
B ´
A ´
Installation bolt 1
Plasma display housing
Stop screwing down the
bolt when the threads are
no longer visible.
Screw holes used with
stand orientation
B, B'
A, A'
B, B'