Installation Method - Pioneer PDK-TS03 Manual De Instrucciones

Stand attaching to the Plasma Display
1. Place a sheet or protective cover to protect the display from scratches or damage.
2. Assemble only with the plasma display lying flat on a table or similar surface.
Notes
3. Insert the bolts vertically in the holes and tighten them, but do not apply excessive pressure that tightens them
more than necessary.
4. Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly.
5. The display is a 50" model that weighs approximately 40 kilograms (88 lb) and has little depth, making the
display very unstable. For this reason, at least two people are required for setup and installation.

7 Installation Method

With the plasma display lying flat, insert and secure the two Installation bolts 1 (M8 x 20)
Step 1.
in the holes "a" located in the plasma display housing.
At this point, tighten these bolts 1 only until the threads are no longer visible when
viewed from t he side (you will be unable to attach the display if the bolts are screwed in
completely).
Plasma display
¶ Regarding the stand pipe screw holes when the stand is used as a desktop stand
C
B
A
C ´
B ´
A ´
12
Table: Stand pipe screw holes when the stand is used as a desktop stand
Plasma display
model
C
50"
B
A
C ´
B ´
A ´
43"
Note: Screw holes C and C' are not for routine use. (They are used for separately sold
options.)
Installation bolt 1 (M8 x 20)
Holes "a"
(holes in center of
plasma display)
Specifications
Without optional speakers
With optional speakers attached to both sides
of display
Without optional speakers
With optional speakers attached to both sides
of display
With optional speakers attached at bottom of
display
Installation bolt 1
Plasma display housing
Stop screwing down the
bolt when the threads are
no longer visible.
Screw holes
used with stand
orientation
B, B'
A, A'
B, B'