Pioneer PDK-FS03 Manual De Instrucciones página 11

4
When using a shelf.
A shelf can be attached to the stand.
1 Remove the shelf cover and then attach the shelf supports
L and R to the stand.
Push rivet
Shelf support L
2 Push the shelf panel in from behind and fix it in place with
the push rivet.
The shelf panel installation position be selected from
two levels: either the front or the back.
Set it accorrding to the device you have.
When changing its position, you can easily remove it
by pulling up the knob on the top of the push rivet.
nterior dimensions of the shelf opening: 420 mm [16-
I
17/32 inch] (effective width) <opening 436 [17-5/32] >
x 102 mm [4-1/32 inch] (height)
Depth of the shelf: 349 mm [13-3/4 inch]
Bearing capacity: up to 10 kg [20.1 lbs]
Note
Be careful when installing anything other than a media
receiver (particularly an AV amplifier etc.) on this shelf,
because it may block heat discharge etc. For details, see
the instruction manual for each device.
Unlocked
position
Locked
position
Front side
5
Shelf cover
Shelf support R
Push rivet
Push in
6
Hole for front
position use
Hole for back
position use
Shelf panel
Push rivet
c k
B a
o n
s i t i
p o
n t
F r o
o n
s i t i
p o
Installation and assembly instructions
When attaching a media receiver upright.
Put the media receiver installed on a upright use stand (see
the plasma display operating instructions for the installation
method) on the shelf at the rear and fix the upright use stand
in place with the MR stand's front and back metal fittings.
Note
Do not install any device other than a media receiver in this
position.
MR stand's front
metal fitting
Installing base covers L, R, and rear.
Insert them along the base.
Base cover L
Base cover rear
MR stand's
back metal
fitting
Media receiver
Base cover R
11
En