Continuity Test - Multimetrix CM 605 Manual De Instrucciones

7.7 CONTINUITY TEST

Please read the safety recommendations before use. There
must be no voltage in the circuit.
1. Set the selector (8) to
2. Insert the black cable in the COM terminal (1), the red cable in
the + terminal (10) and apply the contact points to the circuit to
be checked.
The buzzer sounds when the circuit to be checked is DC or has a
resistance of less than 100 Ω ± 20 Ω.
3. Set the selector to OFF.
7.8 ANALOG OUTPUT SIGNAL
Please read the safety recommendations before use.
1. Set the selector (8) to
2. Insert the cable in the COM terminal (1) and another in the +
terminal (10). Connect the ends of both cables to an
oscilloscope or another multimeter.
3. Press the handle (3) to open the clamp (5) and place the
conductor in the centre (Fig. 3).
4. Close the clamp and read off the analog signal on the
oscilloscope or multimeter.
If the signal measured is continuous, the output signal will be DC. If
the signal measured is alternating, the output signal will be AC.
5. Open the clamp, release the conductor and set the selector to
OFF.
7.9 MAX FUNCTION (DISPLAYING THE MAXIMUM VALUE PEAK)
1. Set the selector to
icon is displayed (17).
2. Take the measurement.
The maximum measurement will be updated automatically.
3. Press HOLD for 2 seconds to deactivate the PEAK function.
7.10 HOLD FUNCTION (DATA HOLD)
1. Set the selector to
seconds.
The icon
2. Take the measurement.
The measurement is stored
3. To deactivate the function, press HOLD during 2 seconds (7).
The icon
7.11 RELATIVE MEASUREMENT
1. Press the
The icon appears: the value is stored in memory as the reference
value for the subsequent measurements. Press the
again (9) to exit Zero mode.
8. TO REPLACE THE BATTERIES
Please read the safety recommendations before use.
There must be no voltage in the circuit.
The two batteries type AAA must be replaced when the
displayed:
1. Disconnect the contact points.
2. Set the selector to OFF.
3. Remove the fixing screws and the battery compartment cover.
Replace both the 1.5V type AAA batteries, paying careful
attention to the polarities.
4. Replace the cover and fasten the screws.
NB: Remove the batteries if the multimeter will not be used for a
prolonged time.
or
is displayed (rep. 18).
disappears (rep. 18).
ZERO button (9) to activate Zero mode.
.
.
and press HOLD (7) until the
and press HOLD (7) during 2
13
ZERO button
icon (13) is