Recording; Basic Operation - Teac A-H300mkII Manual Del Usuario

Basic Operation

2
3
1 To protect speakers from a sudden high-level signal,
turn the VOLUME knob counterclockwise to minimize
the volume.
∞
– (infinity): minimum volume
0dB: maximum volume
2 Press the POWER switch.
The unit enters standby mode, and the standby indicator
lights.
3
Press the STANDBY/ON switch to turn the unit on.
4
Select a source by turning the INPUT SELECTOR (or
pressing one of the INPUT SELECTOR buttons of the
remote control unit).
5
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob.
10
1 5
4
The standby indicator
goes off.

Recording

1 Select a source to be recorded by turning the INPUT
SELECTOR.
Do not select TAPE 1 or TAPE 2.
2 Set the REC SELECTOR to "SOURCE".
3 Start recording on the cassette tape deck connected to
TAPE 1 or TAPE 2 (or both).
You can use both TAPE 1 and 2 for recording.
< The volume and tone control have no effect on the recording
signals.
< You cannot record (or dub) when the CD direct function is
on, because no sound is output from the TAPE REC jacks. If
the CD DIRECT indicator is lit, press the CD DIRECT button to
turn it off.
INPUT SELECTOR
REC SELECTOR