DeWalt DW735 Manual De Instrucciones página 13

WARNING: To prevent the planer from starting unexpectedly if
power is interrupted by a circuit breaker trip, make sure the switch
is in the OFF position before restoring power.
NOTE: Circuit breaker overload is often the result of dull knives.
Change your knives on a regular basis to avoid tripping your
breaker. Check your knives before re-setting the circuit breaker
and continuing to plane.
See the Troubleshooting Guide on page 14 for additional informa-
tion on circuit breaker trips.
Replacing the Drive Belt
Drive belts are available at extra cost at D
service centers. Replacement of the drive belt should be performed
by qualified service personnel.
Chip Ejection Fan
The chip ejection fan on your planer should be
cleaned or cleared of debris periodically.
NOTE: TURN OFF AND UNPLUG THE PLANER
PRIOR TO ACCESSING THE CHIP EJECTION
FAN.
TO ACCESS THE FAN
1. Remove the top cover of the planer with the T-wrench.
2. Remove the dust shroud (Fig. 2, 3) and place it aside.
3. Remove the screws around the fan housing.
4. Remove the fan housing and place it aside as shown. The fan
will now be exposed for cleaning.
See the Troubleshooting Guide, page 14, for additional information.
WARNING: Be sure to properly attach the fan housing and
assemble the shroud and top cover correctly before using your
planer again.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your distributor or local service center.
Four accessories are available for the DW735 Thickness Planer.
• DW7350 Mobile Stand
• DW7351 Folding Tables
• DW7352 13" Knives
• DW7353 Chip Ejection Accessory
CAUTION: The use of any other accessory not recommended
for use with this tool could be hazardous.
If you need any assistance in locating these accessories, please
WALT authorized
E
contact D
Baltimore, MD 21286 or call 1-800-4-D
www.dewalt.com
DW7351 Accessory Folding Tables
WARNING: For your own safety, read the tool instruction man-
ual before attaching the tables. Failure to heed these warnings
may result in personal injury and serious damage to the planer
and the accessory. When servicing this tool, use only identical
replacement parts. Have damaged cords replaced by an author-
ized service center.
Your DW7351 folding table box should include:
2 folding tables
4 springs
4 stepped Allen bolts
SET-UP AND INSTALLATION OF
BASE HARDWARE
1. Place planer on a secure table or workbench. Position planer so
the front 3-4" of the base can be accessed from the underside.
11
WALT Industrial Tool Co., 701 East Joppa Road,
E
WALT (1-800-433-9258) or
E
4 Allen cap screws
4 nuts