Installation Of The Pump Kit Ps - EMAK efco FR 46 Manual De Instrucciones

I
NSTALLATION OF THE PUMP KIT
Figure 2 Remove backrest
C
A A B
Figure 3 Remove grid
A A
Read and follow these steps to install
the mist blower conversion kit from a
model MB90 /
pump.
See Figure 2 to remove the backrest and
access the area where the pump will be
installed.
 Move the padding and unscrew the
screws A (keeping the nut) to remove
the backrest from the chassis.
 Unscrew the three screws B in order to
remove the protective grid.
 Unscrew the red liquids tank cap;
remove the white plastic cap form the
bottom of the tank, at the center, as
shown in the box at the top left of
Figure 3.
 Disconnect the hose C from the liquid
tank enlarging the blocking ring with a
plier. Disconnect also the hose C from
the handle on the throwing pipe.
 Store the hose C.
13
Pump PS
PS
AT 900 with booster