Important Charging Notes - Bosch SPS10 Instrucciones De Funcionamiento

BM 2609140567 07-08
AUTOLOCK™
Your tool is equipped with an automatic locking
system. This feature will lock the bit holder in
one position when the trigger switch is
released. This will allow you to tighten or loosen
a nut or screw by rotating the tool by hand with
INSERTING AND RELEASING
BATTERY PACK
Release battery pack from tool by pressing on
both sides of the battery release tabs and pull
downward (Fig. 4).
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
If the indicator lights are "OFF", the charger
is not receiving power from power supply
outlet.
If the green indicator light is
"BLINKING", the battery
pack is being fast-charged.
Fast-charging will automatically stop when
the battery pack is fully charged.
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger
will not fast charge the battery. (This may
happen if the battery pack is hot from heavy
use). When the battery temperature returns to
between 32˚F (0˚C) and 113˚F (45˚C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced.
7/22/08 4:29 PM
CHARGER INDICATORS, SYMBOLS AND MEANING

IMPORTANT CHARGING NOTES

Page 9
the switch off. This is convenient when higher
turning torque is needed.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when driving (Fig. 1).
BATTERY
PACK
If the green indicator light is
"ON",
plugged in but the battery
pack is not inserted, or the battery pack is
fully charged, or the battery pack is too hot or
cold for fast-charging. The charger will
automatically switch to fast-charging once a
suitable temperature is reached.
3. Remember to unplug charger during storage
period.
4. If battery does not charge properly:
a. Check for voltage at outlet by
plugging in some other electrical device.
b. Check to see if outlet is connected to
a light switch which turns power "off" when
lights are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
-9-
FIG. 4
BATTERY
RELEASE
TABS
the charger is