Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
In the event of changing batteries of the units, ensure the batteries do not spring free from the contacts.
Always wait at least 1 minute after removing the batteries before reinserting, otherwise start up and
transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1.
User shall remove all the batteries from the weather station and transmitters, and wait 60 seconds.
2.
Insert the batteries in the first transmitter.
3.
Within 2 minutes of powering up the first transmitter, insert the batteries in the weather Station. Once
the batteries are in place, all segments of the LCD will light up briefly. Following the indoor
temperature/humidity and the time as 0:00 will be displayed. If these information are not displayed on
the LCD after 60 seconds, remove the batteries from both units and wait for at least 60 seconds
before reinserting them.
4.
The outdoor temperature data from the first transmitter (channel 1) should then be displayed on the
weather station. Also, the signal reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset from step 1.
5.
Insert the batteries in the second transmitter as soon as the outdoor temperature readings from the
first transmitter are displayed on the weather station.
Note : User shall insert the batteries into the second transmitter within 30 seconds after the weather
station displays the information of the first transmitter.
6.
The outdoor temperature from the second transmitter and the "channel 2" icon should then be
displayed on the weather station. If this does not happen after 2 minutes, the batteries will need to be
removed from all the units and reset from step 1.
7.
Insert the batteries in the third transmitter as soon as the "channel 2" icon and outdoor data are
displayed on the weather station. Then within 2 minutes, the channel 3 outdoor data from the third
transmitter will be displayed and the channel icon will shift to "3" once the third transmitter is
successfully received. If this does not happen, user shall restart the setting up from step 1.
Note : User shall insert the batteries into the third transmitter within 30 seconds after the weather
station displays the information of the first transmitter or immediately after reception of the second
35
Publicidad
Tabla de contenido
