hafele DT 100 FH Instrucciones De Montaje página 7

Commissioning
Assigning the Programming ADD and DELETE keys
In simple operating mode the Programming ADD and DELETE keys must
be assigned during commissioning.
Attention!
In order to prevent abuse of the user keys by unauthorised persons:
keep Programming ADD and DELETE keys in a safe place.
1. Get the green programming ADD key and the red programming
DELETE key and keep them close by for the following steps.
2. Present the green programming ADD key in front of the DT 100 while
the green LED is blinking. The green LED lights up in con-firmation.
After removal of the green programming ADD key the red LED blinks.
3. Present the red programming DELETE key in front of the DT 100 while
the red LED is blinking. The red and green LEDs light up simultane-
ously. The DT 100 switches off automatically. Assignment of the Pro-
gramming ADD and DELETE keys has been completed.
If errors occur during assignment:
Switch on the DT 100 again. (See Step 2)
Assign the Programmer and Deletion Key again.
If errors re-occur:
Contact the Dialock sales office.
58 DT 100 - Status: 08.2011 - 732.29.137
Mounting and Operating Instructions