Energy Saving Tips; Connecting The Cooler - Waeco CF35 Instrucciones De Uso

Operation
6.2

Energy saving tips

 Choose a well ventilated installation location which is protected
against direct sunlight.
 Allow warm food to cool down first before placing it in the device
to keep cool.
 Do not open the cooling device more often than necessary.
 Do not leave the cooler unit open for longer than necessary.
 Defrost the cooler once a layer of ice forms.
 Avoid unnecessary low temperatures.
6.3

Connecting the cooler

Connecting to a battery (Vehicle or boat)
The cooler can be operated with 12 V or 24 V
NOTICE! Danger of damage!
A
Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system
to prevent the polarity reversal. This protects the cooler against
short-circuiting when connecting to a battery.
➤ Plug the 12/24-V connection cable (fig. 1 2, page 3) into the
DC voltage socket and also into the cigarette lighter or a 12 V
or 24 V socket.
Connecting to a 100–240 V AC mains (E.g. in the home or office)
DANGER! Danger of electrocution!
D
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your cooler on board a boat from a mains
connection of 100–240 V~, you must install a residual current
circuit breaker between the 100–240 V AC mains and the
cooler.
Seek advice from a trained technician.
32
CoolFreeze
.
g
EN