Energy Saving Tips; Connecting The Cooler - Waeco CF-80 Instrucciones De Uso

_CF-80_110.book Seite 30 Montag, 8. Januar 2007 2:43 14
Operation
6.2

Energy saving tips

Choose a well ventilated installation location which is protected
from direct sunlight.
Allow hot food to cool down first before you place it into the
device.
Do not open the cooler more often than necessary.
Do not leave the lid open for longer than necessary.
Defrost the cooler once a layer of ice forms.
Avoid unnecessary low temperatures.
6.3

Connecting the cooler

Connecting to a battery (Vehicle or boat)
The cooler can be operated with 12 V or 24 V DC.
Caution – Danger of damaging the device!
Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system
to prevent the polarity reversal. This protects the cooler against
short-circuiting when connecting to a battery.
Caution - Danger of damaging the device!
To avoid drops in voltage and therefore performance, keep the
cable as short as possible and only disconnect it when necessary.
For this reason avoid additional switches, plugs or power strips.
➤ Determine the required cross section of the cable in relation to
the cable length according to Fig. 6, page 5.
Key for Fig. 6, page 5
Co-ordinate axis
30
All manuals and user guides at all-guides.com
Meaning
l Cable length
∅
Cable cross section
Unit
m
mm²