Virutex CE96H Manual De Instrucciones página 8

REPLACING BLADES
Loosen screws D (Fig. 7) with the blade securing
key and move the blade laterally to free it from
the support.
Place a new blade into the support or use the second
cutting edge of the blade just extracted.
With the help of a ruler, S, confirm that the side of
the blade reaches the level of the shoe and the base
without protruding and tighten the screws D (Fig. 7).
It is very important to verify the side of
the blade with the ruler; if it exceeds
the level of the shoe or the base, it will
rub against the lateral fence when the
square is being used.
ADJUSTING BLADES
The blade supports are already adjusted from the
factory and do not require readjustment when the
blades are changed. However, if you wish to readjust
them, proceed as follows:
Set the shoe to "0" using knob C (Fig. 7).
Place a ruler S, between the shoe and the base and
loosen screws E of the blade support to lift or lower
the blade until it is perfectly even with the ruler and
parallel to the base of the machine (Fig. 7).
Ensure that screws D (Fig. 7) are
correctly tightened before resuming
work with the machine.
For blade-holder system spares use only original
VIRUTEX components.
8. CHANGING THE TRANSMISSION BELT
Disconnect the machine from the
power source before performing the
following operation.
Unscrew screws G (Fig. 8) and remove protection F.
Replace the worn belt with a VIRUTEX original spare,
taking care to fit it correctly into the pulley teeth,
never forcing it.
9. DUST COLLECTOR CONNECTION
To assemble the dust collector connection, detach
the shaving outlet guide H (Fig. 9) by removing
screw I and insert the dust collector connection in
the same opening.
8
The planer may be connected to the Virutex Vacuum
cleaner AS182K, AS282K either directly or by means
of a dust collector attachment 6446073. This attach-
ment may also be used to connect the planer to any
industrial sawdust collector.
10. MAINTENANCE OF THE
BRUSHES AND COLLECTOR
Disconnect from the mains before ca-
rrying out any maintenance operations.
The brushes must be replaced when they reach a
minimum length of 5 mm (Fig. 8).
Unscrew the black caps J (Fig. 8) on the housing and
remove the brushes from the guide. Replace them
with new VIRUTEX original spares, ensuring that they
move smoothly inside the guides. Screw on the cap
J which covers them and leave the machine running
for 15 minutes. If the collector is burned or uneven
it should be repaired by a VIRUTEX service agent.
Always keep the lead and plug in good working condition.
11. NOISE LEVEL AND VIBRATIONS
The noise and vibration levels of this device have
been measured in accordance with European stan-
dard EN 60745-2-14 and EN 60745-1 and serve as
a basis for comparison with other machines with
similar applications.
The indicated vibration level has been determined
for the device's main applications and may be used
as an initial value for evaluating the risk presented
by exposure to vibrations. However, vibrations
may reach levels that are quite different from the
declared value under other application conditions,
with other tools or with insufficient maintenance
of the electrical device or its accessories, reaching a
much higher value as a result of the work cycle or
the manner in which the electrical device is used.
Therefore, it is necessary to establish safety measures
to protect the user from the effects of vibrations,
such as maintaining both the device and its tools
in perfect condition and organising the duration
of work cycles (such as operating times when the
machine is subjected to loads, and operating times
when working with no-load, in effect, not in use, as
reducing the latter may have a considerable effect
upon the overall exposure value).
12. WARRANTY
All VIRUTEX power tools are guaranteed for 12 months