Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SERVICE AND ADJUSTMENTS
o o
o
WARNING: TO AVOID SERIOUS iNJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress brake pedal fully and set parking brake.
Ensure transa×le
is in the neutral position.
Place attachment clutch in "DISENGAGED"
position.
= Turn ignition key to "STOP" and remove key.
= Ensure the blades and all moving parts have completely stopped.
= Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TO REMOVE
MOWER
(See Fig. 35)
•
Place attachment clutch in "DISENGAGED"
position.
•
Lower attachment lift lever to its lowest position.
•
Disengage belt tension rod (K) from lock bracket (L).
loaded. Have a tight
grip on rodand
release slowly.
•
Remove mower belt from electric clutch pulley (M).
•
Disconnect front link (E) from mower - remove retainer
spring and washer.
•
Goto eitherside ofmower anddisconnect mowersuspen-
sion arm (A) from chassis and rear lift link (0) from rear
mower bracket (D)- remove retainersprings andwashers.
•
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
CAUTION: After rear lift links are discon=
nected, the attachment
lift lever will be
spring loaded.
Have a tight grip on lift
lever when changing position of the lever.
From right side of mower, disconnect anti-sway bar (S)
from right rear mower bracket (D) - remove retainer
spring and washer and pull mower toward you until the
bar falls from the hole in bracket.
Turn tractor steering wheel to the left as far as itwill go.
Slide mower out from under right side of tractor.
TO INSTALL
MOWER
Follow procedure described in "INSTALL MOWER AND
DRIVE BELT" in the Assembly section of this manual.
Fig. 35
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 36)
MOWER DRIVE BELT REMOVAL
•
Park tractor on a level surface. Engage parking brake.
•
Lower attachment lift lever to its lowest position.
•
Disengage belt tension rod (K) from lock bracket (L).
_
CAUTION: Belt tension
rod is spring
dBL
loaded.
Have a firm grip on rod and
release slowly.
•
Remove screws (P) from mandrel covers (Q) and
remove covers.
•
Remove any dirt or grass clippings which may have accu-
mulated around mandrels and entire upper decksurface.
•
Remove belt from electric clutch pulley (M), both man-
drel pulleys (R) and all idler pulleys (V).
MOWER DRIVE BELT INSTALLATION
•
Install belt around all mandrel pulleys (R) and around
idler pulleys (V) as shown.
•
Install belt onto electric clutch pulley (M).
IMPORTANT:
Check belt for proper routing in all mower
pulley grooves.
•
Reassemble mandrel covers (Q). Securely tighten all
screws.
•
Engage belt tension rod (K) on locking bracket (L).
CAUTION: Belt tension
rod is spring
loaded.
Have a tight
grip on rod and
engage slowly.
•
Raise attachment lift lever to highest position.
21
Fig. 36
Publicidad
Tabla de contenido
