Husqvarna LGT24K54 Manual Del Propietário página 5

UNASSEMBLED PARTS
(5) 1-3/16
O.D. Washers
Mower
(2) Rear
Lift Link _
Assemblies
(1) Small
Retainer Springs
(5) Large
Retainer Springs
(1) Front
Lift Link
Assembly
if Equipped
©
(1) Anti-Sway Bar (1) 3/40.D.
Washers
(1) Small Retainer
Springs
Mower Front Wheel
(1) Shoulder Bolt
(1) Wheel
(i) i-i/40.D.
Washer
©
(1) 3/8-16
Locknut
(1) Oil Drain Tube
Slope Sheet
Keys
(2) Keys
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(2) 7/16" wrenches
(1) 1/2" wrench
(1) 3/4" wrench
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench Flashlight
Utility knife
Tire pressure gauge
Pliers
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or cartons and
remove.
When right or left hand is mentioned in this manual, it means
when you are in the operating position (seated behind the
steering wheel).
5