Leveling - Whirlpool CGT9100GQ Instrucciones De Instalación

Optional,
3-wire connection:
Use for direct wire or power supply
cord where local codes do not permit
connecting cabinet-ground conductor
to neutral wire.
1. Remove center terminal block screw.
2. Remove neutral ground wire from
external ground conductor screw.
Connect neutral ground wire and the
neutral wire (white or center wire) of
power supply cord/cable under center
terminal block screw. Tighten screw.
3. Connect the other wires to outer
terminal block screws (hooks facing
right). Tighten screws.
4. Tighten strain relief screws.
5. Connect a separate copper ground wire
from the external ground conductor
screw to an adequate ground.
6. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover
with hold-down screw.
Leveling Stacked Washer/Dryer
Leveling your washer/dryer properly reduces excess noise
and vibration.
1. Remove cardboard from beneath washer/dryer. Place a level
on top edges of washer/dryer, checking each side and front.
If not level, tip washer/dryer and adjust feet up or down as
shown in Steps 3 and 4, repeating as necessary.
ELECTRIC DRYER ELECTRICAL CONNECTIONS
A
A. External ground conductor screw
B. Center terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
E. 3/4" (19 mm) UL Listed strain relief
F. Grounding path determined
by a qualified electrician
Not Level
B
C
D
E
F

LEVELING

LEVEL Not Level
29