Reversing Dryer Door Swing (Optional) - Whirlpool CGT9100GQ Instrucciones De Instalación

Remove the Door Assembly
1. Place a towel or soft cloth on top of dryer or work space
to avoid scratching of the surface.
2. Remove three of the four screws that hold the door hinge
on the front panel of the dryer. Partially loosen the remaining
screw with keyhole opening and lift the door off the screw.
3. Lay the door assembly on a previously prepared fl at surface
with the inside (inner door assembly) facing up, and remove
six Phillips head screws to release outer door assembly from
inner door assembly.
NOTE: It is important that you remove only the six indicated
screws.

REVERSING DRYER DOOR SWING (OPTIONAL)

4. Lift the inner door assembly off outer door assembly.
5. Remove four Phillips head screws to release center insert
from outer door ring.
6. Lift and rotate center insert 180 degrees.
7. Reassemble the center insert and outer door ring
with the four screws.
31