Stereo Recording And Playback; Second Audio Program (Sap) - memorex MVD4540B Manual De Instrucciones

Stereo recording and playback / Second Audio Program (SAP)
Stereo recording and
playback
The VHS Hi-Fi audio system permits high
fidelity recording of MTS STEREO TV
broadcasts.
OPEN/
POWER EJECT
CLOSE
1 2 3
4 5 6
7 8 9
CH
TRACKING/
SET
–
SELECT/
ENTER
CH
SETUP/ CLEAR/
DVD MENU
VCR MENU CANCEL
MARKER ZOOM TOP MENU
AUDIO/ JUMP/ ANGLE/
AUDIO SELECT ZERO RETURN COUNTER RESET
SUB TITLE/ PLAY MODE/
TIMER REC
ATR
REW/SEARCH PLAY
STOP
INDEX/SKIP
REC/OTR SLOW
NOTES:
• When playing back a tape that is not
recorded in Hi-Fi stereo mode, the
audio will automatically be monaural.
• When listening to a VHS Hi-Fi video
tape or MTS broadcast through the
VHF/UHF jack (Audio/Video cord not
connected), the sound will be
monaural.
2C51001AE (26-31)
When a MTS STEREO broadcast is
received, the word STEREO will ap-
pear on the screen and the program can
be viewed or recorded in stereo.
The Hi-Fi STEREO recording procedure
is the same as for normal recordings.
NOTE:
VCR/DVD
When using a CATV system, stereo TV programs may be transmitted
over a mono cable channel. In this case the word "STEREO" will not
DISPLAY/CALL
appear and the sound will be in mono.
INPUT SELECT/
PROGRESSIVE
Output selection
When viewing an MTS STEREO TV program, or playing a prerecorded
0 VHS Hi-Fi STEREO videotape, press AUDIO SELECT to select how
the audio will be heard through the speakers. Normally set to the Hi-Fi
STEREO position, this button can be set to the MONO position if the
stereo broadcast or videotape audio is of poor quality. The "R" and "L"
positions allow the audio from the Right or Left Hi-Fi channel to be heard
TRACKING/ over both TV speakers. This button has no effect when viewing a MONO
SET
+
videotape or TV program. Each time when you press the button, OUTPUT
SELECTION display appears on the screen for several seconds. Refer
to the chart below.
RETURN
REPEAT A-B
CLOCK/
COUNTER
TV/VCR

Second Audio Program (SAP)

SPEED
Your VCR is fitted with a SAP broadcast system which enables
SEARCH/F.FWD
you to switch to a second audio program when viewing a
selected channel.
This function applies only when the program is broadcast in
SKIP/INDEX
multi-languages through the SAP broadcast system.
1
PAUSE/STILL
2
Listening to SAP
When the VCR is turned on or a channel selection is made, make
certain the letters "SAP" appear on the screen. This means that the
"Second Audio Program" broadcasting is available.
31
OUTPUT SOUND HEARD ON BOTH
SELECTION SPEAKERS
STEREO STEREO
L ch LEFT CHANNEL AUDIO
R ch RIGHT CHANNEL AUDIO
MONO MONO
Press VCR MENU. Then press SET + or – to select "SAP".
Then press ENTER to select "ON".
Then press VCR MENU until the
menu screen is cleared.
STEREO SAP
18/11/03, 2:38 PM
STEREO
MENU
TIMER REC SET
AUTO REPEAT ON OFF
SAP ON OFF
CH SETUP
SYSTEM SETUP
+/-/ENTER/MENU
á ñ
SAP
OR
31