Hama RCR 110 Instrucciones De Uso página 5

5. Installation
Note – Input
Hold down the p button (3) or the ▼ button (2) to select
values faster.
• Press the MODE button (4) repeatedly to switch between the
following displays:
• Temperature
• Alarm mode 1 (ALM1)
• Alarm mode 2 (ALM2)
• Secondary time
5.1. Automatic date/time setting using the DCF signal
• Once you have inserted the batteries, the display is switched
on, an acoustic signal sounds and the alarm clock automatically
starts searching for a DCF radio signal. During the search, the
radio icon will flash. This process can take 3 to 5 minutes.
• When the wireless signal is received, the date and time are
automatically set.
Note – Time settings
• If, during initial setup of the device, no DCF radio signal is
received within the first few minutes, the search is aborted.
The radio icon (6) will go out.
• If there are reception problems, we recommend leaving
the clock to sit overnight, since interference is generally
less at night.
• In the meantime, you can start a manual search for the DCF
radio signal at another location or you can manually set the
time and date.
• The clock automatically continues to search for the DCF
signal every hour. If the signal is received successfully, the
manually set time and date are overwritten.
Display (6)
/
Display flashing
Display steady
(not flashing)
4
Searching for the DCF signal
Active
Successful – signal is being received
Display steady
(not flashing)
Not display
• Press and hold the °C/°F/WAVE button (5) for approx. 3
seconds to start a manual search for the DCF radio signal.
Note – Manual search
• The manual search is automatically aborted after 3-5
minutes.
• Using the wave °C/°F/WAVE (5) frequently will drain the
battery. We recommend only using this function to seek out
an optimal location for the device.
Note – Summer time
The clock automatically switches to summer time.
on the display as long as summer time is activated.
5.2. Manually setting the date/time
• Press and hold the MODE button (4) for approx. 3 seconds until
the hours display begins to flash.
• Set the following information in the order listed:
• Year
• Month
• Day
• Hours
• Minutes
• To select the individual values, press the ▲ button (3) or the 
button (2) and confirm each selection by pressing the MODE
button (4).
• Press the MODE button (4) immediately to adopt the set value
displayed and skip ahead.
• If you do not make an entry for 30 seconds, you automatically
exit the setup mode.
Weekday
• To change the language in which the weekday is displayed,
press the  button (2) for 3 seconds. The current language
will be displayed.
• Hold down the  button (2) to change to the other languages.
Success – weak signal reception
Inactive – no signal reception
appears