Setting Surface Controus - KENMORE ELITE 790.3304 Manual Del Usuario

Setting Surface Controls
Sizes of the Surface Gas
Burners
Your appfiance is suppfied with the
folio%rig 5 different surface gas
burners:
Burner Ca
o 1 Simmer Burner (5,000 BTU) ExtraLarge
o 2 Standard Burners (9,500 BTU)
1 Power Burner (12,000 BTU)
o 1 Power Burner (14,200 BTU) "POWER" ----_l
Burner Head
o 1 Power Burner (17,200 BTU) (12,000BTU)
When setting up the range for
the first time, make sure that the
correct Burner Heads, Burner
Caps and Burner Grates are
Uocated as shown in Figure 1,
Left Front
Gas Opening
Burner Ca
Extra Large
"POWER"
Burner Head
(!4,200 BTU)
Burner Cap
Center Front
Gas Opening
Standard
Burner Head
BTU)
Left Rear
Gas
"Opening
Burner Cap
(Standard)
Standard
Burner Head
Center Rear
Opening
"POWER"
Burner Head
(17,200 BTU)
Small
Burner Cap
"SIMMER"
_ Burner Head
Extra (5,000 BTU)
Large Right Rear
Burner Gas Opening
Cap
jht Front
Gas Opening
Figure 1
Burner
Cap
Burner
Head
Gas
Opening
Electrode must be
located properly in slot of
each Burner Head
Figure 2
Assembly
of the Surface Burner
Heads, Burner Caps,
Burner Grates and F_ue Covers
utis very important to make sure that aH of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctUy
and at the correct Uocations,
1, PUace aH 6 Burner Heads in the correct Uocations (See Figure 1),
Make sure that the correct Burner Head is pUaced with the
corresponding Gas opening and that the Electrode is located
properly in the slot of each Burner Head (See Figure 2), Proper
Burner Head placement insures that each Burner will have the
correct spark required for surface gas ignition,
2, Place the correct Burner Caps at each of the burner locations
(Burner Cap Pilot Hole must face up), Each of the 4 (four) Burner
Heads MUST have a Burner Cap installed to insure proper ignition
and gas flame size and must be in place with the Pilot Hole facing
up BEFORE placing the Burner Grates (See Figure 2),
3, Place the 3 cast iron Burner Grates supplied with the range,
Carefully lift the burners grates on to the cooktop over the burners,
Properly installed Burner Grates will rest with all Grate legs on the
cooktop,
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use,