ELICA SEEYOU Instrucciones De Montaje, Uso Y Mantenimiento página 16

After opening the glass, as specified in
the 'how the hood works ' section of this
manual, you need to fit the grease fil-
ters and the charcoal filters, in case the
hood is used in filtering mode, as well
as the aesthetic grid.
Grease filters are mounted as shown in
fig.11, placing them inside the applian-
ce until they reach their seat; to remove
them, please carry out the reverse pro-
cedure.
Charcoal filters, if necessary, are fit be-
fore mounting the grease filters, by fol-
lowing the same procedure.
After mounting the filters, the aesthetic
grid shall be fit into the related housing,
see figure 11 and 12. The grid is remo-
ved by grabbing it by the specific knobs
shown in figure 12.
How the hood works
In order to operate the appliance, it
is necessary to open the glass by fol-
lowing this procedure:
Push the glass downwards in the front
side, as shown in fig. 9; the glass will be
released and will open of about 2 cm,:
then the glass shall be rotated up to
a 45° or 90° opening , based on your
needs. (see figure 10).
Following the glass opening, it will be
possible to operate the suction motor by
using the push-button panel as follows:
15