Installing Batteries - THERM PRO TP-20 Manual De Instrucciones

LCD Screen
Thermometer mode
EN
Probe 1 Temp
Setting
Probe 2 Temp
Setting
Transmitter Features
2 2
LCD (Liquid Crystal Display) – displays temperatures of both probe 1
and probe 2. It will automatically switch between probe 1 and probe 2
displays.
Wire Stand – Allows you to stand the transmitter on tabletop or it can
be reversed and used as a hanger.
Battery Compartment – holds 2 AAA batteries.
Sensor socket hole – Plug-in for stainless steel probe 1 and probe 2.
Button
ºF/ºC/ – Press once to turn on or off the transmitter. Press and hold for
2 seconds to select the transmitter temperature display in ºC or ºF.
Timer mode
Timer
Meat type
Taste level
Probe 1 Temp
Reading
Probe 2 Temp
Reading
Battery Compartment
LCD
1 1
ºF/ºC/
WIRE STAND
-4-

Installing batteries

Open the battery compartment of the receiver and insert two "AAA"
batteries with correct polarity. Open the battery compartment of the
transmitter and insert two "AAA" batteries with correct polarity.
Turn On/Off Unit
Press button on the receiver to turn on/off the receiver;
Press ºF/ºC / button on the transmitter to turn on/off the transmitter.
Synchronize/Pair Transmitter and Receiver
The transmitter and receiver were already paired at our manufacturing
facility. Usually you do NOT need to re-synchronize or re-pair the units.
You just plug in the probes, insert batteries, turn on the receiver and the
transmitter and wait for a few seconds, you will see the temperatures
shown on both receiver and transmitter and the units are ready for use.
However, in some unusual cases, the transmitter and receiver are no
longer paired, then you may need to re-synchronize them by following
the below steps:
a. Insert the stainless steel probes into the corresponding plugs in the
transmitter.
b. Turn on the transmitter by pressing the ºF/ºC
will show the current temperatures on its LCD display.
c. Turn on the receiver by pressing the
d. Press and hold Mode button on receiver for 2~3 seconds to enter the
synchronization mode which will last for 60 seconds. The display
shows "---" and it is flashing.
e. Wait for a moment until the temperature reading shows on the receiver
display, it means the synchronization/Pairing is complete. Your
professional remote cooking thermometer is now ready for use.
Note: The synchronization between the transmitter and the receiver
won't be lost even if you replace the batteries.
/ button. The transmitter
button.
-5-
EN