Lincoln Electric WIRE FEEDER WELDERS 125 Manual De Uso página 14

WIRE FEEDER WELDERS (125, 140)
.025 GROOVE
.035 GROOVE*
See Figure B.6
12. CIRCUIT BREAKER – If the rated input current of the machine is
exceeded this circuit breaker will trip. Press to reset.
13. GAS INLET –Shielding gas connects to this inlet
(This is not available on 125 Amp Unit.)
SETTING UP AND MAKING A FLUX-CORED WELD WITH 125AMP OR 140AMP MACHINES
A. ITEMS NEEDED FOR FLUX
CORED WELDING
1. .035"(0.9mm) Contact Tip
2. Dual Groove Drive Roll.
Wire Diameter & Type
.025"(0.6mm) MIG wire
.030"(0.8mm) MIG wire
.035"(0.9mm) MIG wire
.030"(0.8mm) flux-cored
.035"(0.9mm) flux-cored
3. .035"(0.9mm) NR-211MP Flux-Cored
Wire
4. Black Flux Cored gun nozzle
B 4
TABLE B.1
DRIVE ROLLS
125/140 Amp
Smooth Drive Roll
(Dual Grooves)
Use .025"(0.6mm) Drive Roll Groove
Use .035"(0.9mm) Drive Roll Groove
FIGURE B.6
13
12
5. Welding Gun
7. Work Cable & Clamp
OPERATION
Drive Roll Part
Number
KP2948-1