Installing Batteries; Using The Remote Control; When To Replace Batteries - Teac SL-D930 Manual Del Usuario

Precautions for use
o When using the remote control, point it toward the
remote control signal receiver on the main unit from a
distance of 5 m (16 ft) or less. Do not place obstructions
between the main unit and the remote control.
o The remote control might not work if the remote
control signal receiver on the main unit is exposed to
sunlight or bright lights. In this case, try moving the
main unit.
o Beware that use of this remote control could cause the
unintentional operation of other devices that can be
controlled by infrared rays.

Installing batteries

Remove the cover on the back of the remote control, and
insert 2 AAA batteries into the case, aligning them with
the ¥ and ^ indications. Replace the cover.
Misuse of batteries could cause them to rupture or
leak, which might result in fire, injury or the staining
of nearby materials. Please read and observe the pre-
cautions on page 3 carefully.

Using the remote control

When to replace batteries

If the distance required between the remote and main unit
decreases or if the unit stops responding to the remote
buttons, replace both batteries with new ones.
Dispose of the used batteries according to the instructions
on them or requirements set by your local municipality.
13 13